2 to 1 extension lead - allows 2 lights to be powered from one wiring loom - 1 female connector to 2 male connectors.
Huidige combinatie niet voorradig.
4 to 1 extension lead - allows 4 smaller lights to be powered from one wiring loom - 1 female connector to 4 male connectors.
ersonalise your Compact 4 or Compact 6 LED working light with a custom coloured light bezel. These are coated with a UV-resistant paint to prevent chipping and fading for a lasting finish.
Bezels can only be purchased in conjunction with the Compact working lights and will be fitted to the lights prior to dispatch to prevent voiding warranty.
Give you Compact 4 or Compact 6 lights added protection when not in use or change the light colour with these durable 'clip on' light covers. Available in a choice of transparant or solid colours.
These U shaped cradles offer another great way to mount your Wilderness Lighting LED Light Bars. These can be used to fit any of our duplex light bars from 6" up to 50". Mounting your light bars just got easier.
This 12 volt flasher will flash up to 10 inches of our lights in the patterns below.
ncrease your options of where to mount your DUPEX, CURVE or SOLO LED light bars with this clamp system.
These clamps allow you to mount your light at any angle.
Available in 11 different sizes to accommodate most roll cages, hand rails or handle bar diameters.
These versatile mounting brackets allow any of our SOLO single row lights to be fitted from the top or bottom rather than using the standard fixing points on each end. These brackets can be adjusted up and down the full length of the light until the desired position is obtained before being fixed on the vehicle.
Ready made wiring loom for running 2 small lights together from one power source. The loom is approximately 3 metres long and includes battery eyelet terminals, fuse, relay, switch and twin Deutsche connectors which plug directly into all of our lights.
This loom is only suitable for the Wilderness COMPACT range - for larger lights please see loom for DUPLEX and SOLO models.
Ready made wiring loom for running 2 x Wilderness SOLO, DUPLEX, QUAD AND CURVE lights together from one power source. The loom is approximately 3 metres long and includes battery eyelet terminals, fuse, relay, switch and twin Deutsche connectors which plug directly into all of our lights.
This loom is suitable for Wilderness lights from the DUPLEX, SOLO, CURVE and QUAD range and can power up to 50" of lights, i.